3D Polar Planes

[OpDawg]

I'm new working with 3D, so bear with me...

Version: ACAD 2006

I've established 4 viewports for 3D modeling, front, left, right, iso.

When I'm in front(view) and click a point, then click into left or right views, my polar tracking only enables me to track up/down, left/right (respectively).

I want to be able to move the line 360deg in every viewport, and have my polar tracking only 'track' the corresponding angles (ie 90, 180, 270, etc.)

What am I doing wrong? Any suggestions?

[hendie]

your tracking will be constrained to your current UCS. which is why it "appears" to be only responding up or down
Polar tracking is restricted to 2D, not 3D

[OpDawg]

Is there any way to 'track' the 4 angles independently on each viewport?

I looking to 'snap' a line on x-y, and angle it specifically through tracking in x-z. Is there a certain USC that will enable that? I'm on 'world' if I'm not mistaken.

[OpDawg]

I found this...

http://usa.autodesk.com/adsk/servlet/ps/dl/item?siteID=123112&id=8008463&linkID=2475176

...however I don't know what "DUCS" is?

Any ideas?