View Full Version : Bays, offsets?
16th Jan 2007, 05:59 pm
im drawing a bay window, and wanna offset the the frame to give it some profile - does anyone know how to do this?
im using tape measure and i cant seem to duplicate the arc so it is the same (ie lines up)
16th Jan 2007, 06:05 pm
edit : to offset the line verticaly
16th Jan 2007, 06:18 pm
scrap that lol
anyone know how to draw a bay window, without using arc?
atm im pulling the arc up, like you would a rectangle - but when this is done i cant pull/push anything within the arc area (ie window frame)
16th Jan 2007, 09:55 pm
A bay window with an arc?? Weird, most here in the states are andgled not curved. You obviously have not closed the face or it is interacting with other faces. Copy your bay window and insert into another area of the drawing and make no other lines are touching it. See if you can clean it up and make it push/pull them. if so make a group out of it and move it back into your main model. let us know how you coma along.
16th Jan 2007, 11:54 pm
cheer for the reply, yeah an arched bay window (curves out)
the problem i have found is, that you cannot push pull out if you have pulled the arc up (hard to word)
i will get a screenshot tomorrow, and post what i mean.
Powered by vBulletin™ Version 4.1.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.