June
21st Jun 2007, 05:12 pm
Hi
I have autocad LT 2007. I have just done a load of drawings and getting to the final stages. To check the layout of the drawing on the paper and send it to the surveyor to check certain areas I have plotted to PDF and also pressed the button APPLY TO LAYOUT. I thought I'd mention it as that may be the problem.
Basically I've noticed on one of my drawings the doors do not show on the PDF file and when I go into Layout 2 they come up as grey. Also I tried drawing a line and another door and it does the same. As the drawings are quite simple it has all been done on one layer. I have compared properties of the parts of the drawing that show to parts that don't and I can see no difference.
I've had a look on google and a couple of things have come up about publishing the drawing first, which I've tried but nothing has changed.
I have to print these off tomorrow so I'd be grateful for any ideas.
Thanks
June
I have autocad LT 2007. I have just done a load of drawings and getting to the final stages. To check the layout of the drawing on the paper and send it to the surveyor to check certain areas I have plotted to PDF and also pressed the button APPLY TO LAYOUT. I thought I'd mention it as that may be the problem.
Basically I've noticed on one of my drawings the doors do not show on the PDF file and when I go into Layout 2 they come up as grey. Also I tried drawing a line and another door and it does the same. As the drawings are quite simple it has all been done on one layer. I have compared properties of the parts of the drawing that show to parts that don't and I can see no difference.
I've had a look on google and a couple of things have come up about publishing the drawing first, which I've tried but nothing has changed.
I have to print these off tomorrow so I'd be grateful for any ideas.
Thanks
June