mirror view port image

[Scale]

is their a way to mirror the view port image? like the same way you can rotated it using MVSETUP.

[Cymro]

Not as far as I'm aware

[SLW210]

It depends, are you trying to mirror the Model or is this something you did with _SOLPROF or _SOLDRAW? If it is the Model, why not just change the view? You should be able to mirror the _SOLPROF or _SOLDRAW, but you will have to do it in Modelspace.

[Hedgehog]

If it's a 2D image you could try creating a copy of the viewport, then go into the copy, switch ucsfollow on, then go into the ucs command & flip it using the Y or X planes through 180 deg.


Note... remember to switch ucsfollow off after otherwise the viewport will keep regen'ing & zooming to extents.

[hazardman]

or, if 2d, you could use the bottom view in the viewport (if it was drawn on the top view)...just remember that you text will appear mirrored...