Advice on best place to sell microscribe

[worldly1]

Hello all,
We bought a Microscribe G2X a while back, used it for a short while and now don't see ourselves needing it any more and hate to have it just collect dust. But other than Ebay or Craigslist, we don't know of a good place to sell it. Any suggestions?
Scott

[rustysilo]

Does that company have a user forum where you might sell it at? That would be a good place. Otherwise just throw it on Ebay or Craigslist.

[rustysilo]

Funny, I've been approached by a local company using the Microscribe (http://www.immersion.com/digitizer/) for part-time cadd help. I have a meeting with them this week and I'm wondering what AutoCAD commands do you use when using the Microscribe? Would you simply use the 3dpoly command and then loft sections together or what? Will you please say what your process was when using this product?

[worldly1]

I have not used it in conjuntion with AutoCAD (only Rhino 3d) so can't offer any advise or guidence there.

[rustysilo]

I think the company may have Rhino as well. I know it was mentioned over the phone.