Working with paper space.

[Cadastrophic]

I am teaching myself acad2k, and recently came across your excellent site.
I followed the lesson in Basic 3D, and drew the table. Good fun. I then followed the link to Paper Space, which is where I came unstuck.
One of the first instructions is to double click on Tile. I don't have a Tile button, and tried looking through various drop down menus, to see if I could pick up on some of the key words in the lesson, without any luck.
I realise the lesson was for R14, so can you repeat it for 2000 please?
http://home.online.no/~johmoe/smilies/sadwave.gif

[superjari]

Are you looking for the button to get into paperspace?

This is located all below in your screen, next to the osnap, otrack and those buttons...

[Mr T]

TILE mode is pre-2000. :roll:

Just type LAYOUT

Screenshot attached showing the layout tab as well. Easy to switch between the two MODEL and PAPER space, now layouts.

Nick

Happy Hogmanay !! :P

http://www.eezylearn.pwp.blueyonder.co.uk/tutorials/cad/cadastrophic.jpg