concrete hatch

[richjamesw]

why is it that when i sometimes hatch using the concrete specific one i get random lines rather than the concrete looking pieces?
thanks in advance

[Cad64]

This happens when your hatch pattern is too far from 0,0. You will need to reset your HPORIGIN system variable so that it's closer to your hatch.

This can also be done from within the Hatch dialog.

Not sure if any of this advice will work in LT though? :unsure:

[rustysilo]

It should. The subject has been covered numerous times in forums over the years. Here's the Autodesk Support topic (http://usa.autodesk.com/adsk/servlet/ps/item?siteID=123112&id=2880908&linkID=9240817).