Hickoz_bro
7th Feb 2008, 01:20 pm
2 problems,
1, when i save .IDW files to .DWG the tangent lines in reference data (layer = "EXIST") converts to default layer style (layer = "5L"). is there any way to stop this? is it just me or is this a known issue?
2, Text created using the text command in inventor looses it's line spacing value (TSPACEFAC). typically this value should be set to "1" but in my case TSPACEFAC is set to something less then 1, usually 0.564 or something similarly obscure. however multiline text created in a leader or dimension etc retains correct line spacing.
any suggestions?
1, when i save .IDW files to .DWG the tangent lines in reference data (layer = "EXIST") converts to default layer style (layer = "5L"). is there any way to stop this? is it just me or is this a known issue?
2, Text created using the text command in inventor looses it's line spacing value (TSPACEFAC). typically this value should be set to "1" but in my case TSPACEFAC is set to something less then 1, usually 0.564 or something similarly obscure. however multiline text created in a leader or dimension etc retains correct line spacing.
any suggestions?