UCS World Crosshair 5degrees

[Hardney]

Hi, I've go this xref that I received from another company and everything in the drawing seems to be normal as in the UCS set to World, Snapang set to 0 and Plan set to World also. Now the crosshair of my cursor is about rotated in a 5 degree angle. Is there a way to set it back to 0 when all the settings are the same as mentioned above?

[dumfatnhappy]

draw (or find) a right angle in plan (world) and do UCS/NEW/3POINT to reset it?

old school way of doing it

[rkmcswain]

Does the angle of the crosshairs match the angle of the UCSICON?

[Hardney]

That is actually what I would do normally, but let's say this is a drawing without any right angle, is there a command that allows to correct that little rotation in the crosshair?

[Hardney]

Something weird happened, with all the tests that I asked my coworker to do, nothing happened. But when I opened the drawing in read only, and just did a UCS World, everything was okay. So I asked him to proceed in the original drawing and everything was fine also. Guess he might have not done it the right way at first. Thanks for the help.

->rkmcswain: When I did the UCSICON command and set it to 2d and made a PLAN>World, the cursor and the ucsicon were in the same rotation.