billdapart
21st Dec 2004, 02:42 am
Can any of you tell me what might be causing my problem?
The cylinder looks great rendered in autocad, but then when i put it into bryce it comes out very blocky.. even after smoothing..
is there another setting i could be trying or something?
Could it be the autocad drawing itself?
I'll post images if I can.
The cylinder looks great rendered in autocad, but then when i put it into bryce it comes out very blocky.. even after smoothing..
is there another setting i could be trying or something?
Could it be the autocad drawing itself?
I'll post images if I can.