ucs with a mind of it's own

[big chris]

Hi,

I'd welcome any explanations or solutions for this please.

When I am drawing in 3D the ucs will sometimes revolve on its own for no apparent reason as I am trying to draw now matter how carefully set it.

For instance sometimes when drawing a box: everything is fine until the moment I click the start point for the box. The ucs instantly spins 90 degrees. If I cancel it goes back to the way it was. I tried to show a colleague but then it stopped doing it. He assures me he's had the same problem. We are using 2008 but I experienced the same on 2007.

Many thanks,
Chris Bates

[Tiger]

it's not the Dynamic UCS that's causing it? Try clicking the button DUCS at the bottom of the screen

[big chris]

Blimey - that was quick!
Ok, the DUCS button was depressed so I've switched it off. I'll have to see if it does it again at some point as this is a random incident but many thanks.

Regards,
Chris

[Tiger]

Blimey - that was quick!
Ok, the DUCS button was depressed so I've switched it off. I'll have to see if it does it again at some point as this is a random incident but many thanks.

Regards,
Chris

:oops: I tend to keep CadTutor open all day...

glad to help, hopefully it'll do the trick.