Wall Intersection

[MARK]

DESK TOP 2006

I have two walls intersecting at a right angle. Wall "1" extends from the face of Wall "2" a few inches. When wall "2" is brought to close to wall "1" wall "2" disappears. Is there a setting that will allow a wall to be a minimal distance from a perpendicular wall?:(

Please advise.

THANKS.....

Mark

[Cad64]

I've moved your question to the new Architecture section. :wink:

[MARK]

Where is the "new Architecture section"?

[Cad64]

See below:

[MARK]

Thanks......

[MARK]

If you would please, I need help.

Under the replies column (architecture) it appears that I have had 4 replies to my question posted yesterday. I can't seem to get to them.

Any advise?

Thanks,
Mark

[Cad64]

Well, now you've had 6 replies to this question.

1. Me
2. You
3. Me
4. You
5. You
6. Me

The problem is that no one has come along with an answer yet. I don't use ADT so I'm not much help in this department. Hopefully someone will be along soon.

[Noahma]

your description is kind of confusing, is there anyway you can post a picture of what you are getting?

[chance]

to answer the question. When you select the wall to stretch there should be a bold dot on the end. Select the dot and right click, choose "disallow join" this should solve your problem

[firsrate_caduser]

also if you check both walls are at the same elevation. sometimes when you use objectsnap it is very easy that the wall would move to the midpoint of the other wall.

I hope this would help!

ACAD 2005 ADT