Creating/Inserting a simple structure.

[spittle]

I want to insert a simple structure, which I plan to switch off, all I need is a Point, just so i can create a bandset to display the structure's chainage and level.

That's it, but why's it so bloody diffucult!

Ideally I need a solution by monday.

I've created a surface and an alignment and a long section view.

I now want to draw some pipe fittings in the profile view and then at each fitting, insert an invisible structure to show that fitting's invert & chainage, whenever it needs to be moved I can just move the structure to suit. It would be far to complicated to build all the pipe fittings, not that I even know how to use part builder yet!

Any help would be great. Thanks

Dave

[rustysilo]

This is something I have yet to tackle. Try theswamp.org vertical forums.

[spittle]

I have a great idea. How about, you learn how to do it, and then spoon feed me on how to do it! :D

[rustysilo]

Hehehe. If I hadn't come home early due to feeling under the weather I might give it a shot. The guys over at the swamp should be able to help much quicker though.

[spittle]

I've put a post up on swamp too. I'll also have a crack at it on Monday but I don't really have loads of time that I can spend on it at this stage.