Dirty

[Opc 12]

Does anyone know why i would get a message that says a part or assy is dirty?

[ReMark]

Take a look at some of the posts over at the AutoDesk Discussion Group for Inventor. Here's a link to start with:

http://discussion.autodesk.com/adskcsp/search.jspa?numResults=25&inputEntered=true&source=viewforum%7C78&q=dirty&objID=f78&search.x=12&search.y=12

[Opc 12]

Thanks will do.

[Lazer]

Did you find an answer to your problem? I have never had a message say the part/assy is dirty:?

[Opc 12]

I did somewhere someone corrupted the part. And i think it was because one of our colleagues was working on inventor 11, so there was conflict there.

Oh well sorted it out.

Go have a look at the link provided by ReMark.

Thanks again.