View Full Version : 3D fillet
7th Feb 2005, 04:53 pm
How can I fillet the edges of a 3D solid? Can AutoCAD blend various curved edges (i.e. around corners and bends)?
7th Feb 2005, 05:01 pm
To fillet a sold all you need to do is use the fillet command as you normaly would except when it prompts you to pick you just pick the edge you want filleted.
7th Feb 2005, 05:56 pm
It's also worth pointing out that you can achieve two different results depending on how you do it.
The fillet on the left is the result of filleting all 3 sides at the same time, the one on the right is the result of filleting the 2 horizontal sides first and then filleting the vertical side.
Powered by vBulletin™ Version 4.1.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.