Pickbox Jerking

[Hardney]

Hi, this might be considered as a General AutoCAD issue but since it only happens to me in C3D, I decided to post it here. Could anyone tell me if there is a way of enhancing the performance of the software or just resolving my problem that is the following: After a certain while my pickbox is not moving as fluidly (kink of jerking movement) as at the beginning of my work session. If I Qsave, the pickbox moves more fluidly but it is not long before the problem reoccurs. Does this happen to anyone else?

[BIGAL]

We have some networking issues that cause this from time to time, the qsave may reduce the network traffic as it writes the incremental saves.

[Hardney]

Is there a way to remedy this issue or I just gotta live with it once more?

[rustysilo]

The only time I've really had issues like this was with the laser mice. Sometimes they have a hard time reading the surface you use them on. Other times it seemed to be the driver going bad, or just the mouse itself perhaps.

In Civil 3D I do get choppy behavior around C3D objects with the snaps are on. I turn them off and it's good.

Aside from that I'd have no idea. Is your system adjusted for best performance?