vinod Posted September 23, 2008 Posted September 23, 2008 How can I explode the attached block ? Please get me a solution.. CAR.dwg Quote
NBC Posted September 23, 2008 Posted September 23, 2008 you will need to enter the Block Editor using the command BEDIT at the command line. Then in the Properties dialogue box, towards the bottom, there should be a toggle box which says "Allow Exploding". Set this to Yes. Then BSAVE and BCLOSE. Quote
vinod Posted September 23, 2008 Author Posted September 23, 2008 you will need to enter the Block Editor using the command BEDIT at the command line.Then in the Properties dialogue box, towards the bottom, there should be a toggle box which says "Allow Exploding". Set this to Yes. Then BSAVE and BCLOSE. I got it...!!! Thank you very much Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.