Sarah H Posted November 10, 2008 Posted November 10, 2008 Our office draws all 'drawing information' on a model space, then creates a new DWG for each sheet, and xref in the original with nothing on the model space. So one 'model' can go to many 'sheets'. Is there a way - like the opposite of the xref manager - to go into a dwg and see where it is xrefed TO as opposed to FROM. Obviously you change a model, go to the relevant sheet that you are needing, reload and add a revision number, but the same revised model could be in a dozen other sheets that I don't know about, I need to find them and add revision notes! Quote
NBC Posted November 10, 2008 Posted November 10, 2008 this thread may be of some use: http://www.cadtutor.net/forum/showthread.php?t=22870 Quote
Sarah H Posted November 10, 2008 Author Posted November 10, 2008 Design Center > Search tab > Look for > Xrefs looks like the exact tool I need.... but LT doesn't have a search like this! Oh woe, so close yet so far. Thanks though, I did look back a few pages of threads honestly but couldn't find anything that looked like my query. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.