cadmantom Posted November 16, 2008 Posted November 16, 2008 Hello Ive rearranged my normal angle profile i.e East used to be 0 degrees, but ive changed the 0 degrees to north as i though it would be easier to remember (north=nothing), but ive just tryed to used my polar tracking at 45 degree. so the 1st 45 degree dotted line should be North West sort of way. this hasnt happened, can someone tell me what i have done wrong? The only thing i have discovered so far that it has done a dotted line for polar tracking 180 degrees in the opposite direction. thoughts and advice would be greatly appreciated i have Full AutoCAD Quote
wannabe Posted November 16, 2008 Posted November 16, 2008 Right click on the polar tab at the bottom and make sure the incremental values are set to 45. Same for OTRACK. Quote
soleary Posted November 19, 2008 Posted November 19, 2008 Right click on the polar tab at the bottom and make sure the incremental values are set to 45. Same for OTRACK. Hi cadmantom. Did you get a solution to this? I couldn't replicate your problem. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.