Creating flanges in Inventor 10 [Archive] - AutoCAD Forums
PDA

View Full Version : Creating flanges in Inventor 10

ebjco
20th May 2005, 01:41 pm
Hi,

When I create perpendicular sheet metal flanges in Inventor 10 the corner relief is removed from one side only. In most of the sheet metal shops that I have worked in the corner relief is usually removed in equal amounts from the corners at the base of each flange. Is there a way to set up Inventor to do this?

Regards

EBJ
Mr T
21st May 2005, 08:38 pm
Can you not just extrude/cut them out after ?

Nick
ebjco
21st May 2005, 10:45 pm
Hi,

That's a good idea. Thanks.

EBJ
Mr T
23rd May 2005, 07:22 pm
No worries, glad someone appreciates the help.... :D

Nick