ebjco
27th May 2005, 12:50 pm
Hello,
When I place ordinate dimensions in inventor 10 along the X axis, the dimension text aligns itself horizontally with the bottom of the part.
This causes a lot of crowding of the dimensions.
Is there a way to get the text to align itself perpendicular to the X axis? This is the way I was taught to do ordinate dimensioning.
Regards
EBJ
When I place ordinate dimensions in inventor 10 along the X axis, the dimension text aligns itself horizontally with the bottom of the part.
This causes a lot of crowding of the dimensions.
Is there a way to get the text to align itself perpendicular to the X axis? This is the way I was taught to do ordinate dimensioning.
Regards
EBJ