Siberian Posted January 15, 2009 Share Posted January 15, 2009 I was in the Piping workspace drawing a pipe in the 'Waste piping' system. When I was done I noticed that the pipe had been placed on the layer named 'H-MedicalGas-G' which can't possibly be right...? Quote Link to comment Share on other sites More sharing options...
Hedgehog Posted January 16, 2009 Share Posted January 16, 2009 Waste Piping system... is this an add-on CAD package? Quote Link to comment Share on other sites More sharing options...
iain9876 Posted January 16, 2009 Share Posted January 16, 2009 I was in the Piping workspace drawing a pipe in the 'Waste piping' system. When I was done I noticed that the pipe had been placed on the layer named 'H-MedicalGas-G' which can't possibly be right...? wastepipe on the wrong layer... Sounds like a job for the plumber....! yea I reccomend you call one immediately! Quote Link to comment Share on other sites More sharing options...
Hedgehog Posted January 16, 2009 Share Posted January 16, 2009 wastepipe on the wrong layer...Sounds like a job for the plumber....! yea I reccomend you call one immediately! Duh!... this is CAD... if it was blocked you'd just explode it... no need for a plumber! Quote Link to comment Share on other sites More sharing options...
Siberian Posted January 16, 2009 Author Share Posted January 16, 2009 Waste Piping system... is this an add-on CAD package? No, it's way down in the system-list in the Piping workspace. Quote Link to comment Share on other sites More sharing options...
Hedgehog Posted January 16, 2009 Share Posted January 16, 2009 ABS? MEP?... or ordinary AutoCAD? /edit... ah sorry... this is the MEP forum... I was looking at youir profile which just says AutoCAD 2009 ... sorry... while I have MEP installed we don't use it any more... shifted over to CadDuct. Quote Link to comment Share on other sites More sharing options...
LifeoRiley0 Posted January 19, 2009 Share Posted January 19, 2009 Siberian, I don't see waste piping on mine but can't you layer isolate then change the system in the properties box? Quote Link to comment Share on other sites More sharing options...
GolfBum Posted January 21, 2009 Share Posted January 21, 2009 Try changing the system....In 09 select a piece of pipe (or Fitting) in the a run of pipe ...Right click and go to modify run....Look on the right side of the drop down boxes for system on the left you will see your current system......change the system in the drop down box and you should be on the correct layer.....If not then it is a layer key issue Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.