Trouble in Paper space Land

I am haveing a problem with layout. I have made some changes to a dwg anin model space and now when I go to paper space and try to do a view the dwg is real small in the middle of the view sheet. when I zoom the dwg is is very out of sorts that is not work able can Anyone help me out these are old dwg that have not needed any up dates until now they were printed out years ago and now I need to make new ones

what version was it created in?

have you accidentally zoomed out in an unlocked viewport?

if you zoom extents your model space does it have the same effect?

You could click inside the viewport and do a "zoom all" but at some point you'll need to establish a scale for the viewport. Do you know what you'll be using?

what version was it created in?

 

have you accidentally zoomed out in an unlocked viewport?

 

if you zoom extents your model space does it have the same effect?

I am not sure just what version the real dwg are in but I think R14

also I can zoom in model space with out any trouble just paper space. thanks for the reply. Some other people and messed with this dwg b4 I got then and had thing all screwed up big time

You could click inside the viewport and do a "zoom all" but at some point you'll need to establish a scale for the viewport. Do you know what you'll be using?

thanks but already tried that to no avail. I really think that this was done in autocad r somthing and a very large scale was used in the first dwg this dwg covers 5 sq miles of space dwg has been worked on by others that did not save anything to show what was done

You have LT 2007 and the drawing was maybe created in R14. Neither fact should play a role in the problems you're having. Have you taken any of the advice so far? If so, what were the results?

did R14 have the modelspace/paperspace facility?

can you post the file for somebody to take a look at properly?

did R14 have the modelspace/paperspace facility?

 

can you post the file for somebody to take a look at properly?

I an not sure about model or paper space I can not send you the file it is to large for the form site

Strix: Yes, r14 had Paper Space. It was renamed to Layout after this version.

You have LT 2007 and the drawing was maybe created in R14. Neither fact should play a role in the problems you're having. Have you taken any of the advice so far? If so, what were the results?

Yes I have talked to people and to you all and still to no avail. but still working on this problem with out haven to rebuild the whole dwg over agan. I am not sure that R14 had paper space? or it was done just in Model and they used a block file to plot out the dwg for a hard copy

Strix: Yes, r14 had Paper Space. It was renamed to Layout after this version.

I was pretty sure but it does not work in Autocad Map 3D 2006 eather

You can't get the drawing to fill the viewport in your layout?

have you tried deleting the viewport and just creating a new one?

You can't get the drawing to fill the viewport in your layout?

Yes but the dwg is very small almost a dot and when I zoom it it just become distorted beyond use model space shows it just fine

have you tried deleting the viewport and just creating a new one?

yes and it still stays very small and then zoomed it is destorted and I can not use it I tryed several ways to get it to show up in any kind of a view in paper space

Go into model space and WBlock out whatever is in there to your hard drive. Then open a new drawing and insert what you saved.

Ok will give it a try thanks

Can you get hold of the ORIGINAL? the one b4 anyone messed it up?