inamars
15th Feb 2009, 10:14 pm
hi guys,
hope it is not off topic
found here in Czech Rep company which can produce 6,5 - 7,5m aluminim hull for RIB in 4mm AlMg4,5 or 5052-H36 for about 2000eur.
what I need before of all is project.
one nice project I found at SPECMAR DOT COM
under RIBs are .pdf files ... 1114 or 1311 ...
really very, very nice but projects cost 3000USD :-((
so
I'm looking for free or low cost project for aluminium hull (6,5 - 7,5m RIB)
any suggestions ?
thank you all for reading
Robert SKET
hope it is not off topic
found here in Czech Rep company which can produce 6,5 - 7,5m aluminim hull for RIB in 4mm AlMg4,5 or 5052-H36 for about 2000eur.
what I need before of all is project.
one nice project I found at SPECMAR DOT COM
under RIBs are .pdf files ... 1114 or 1311 ...
really very, very nice but projects cost 3000USD :-((
so
I'm looking for free or low cost project for aluminium hull (6,5 - 7,5m RIB)
any suggestions ?
thank you all for reading
Robert SKET