Dynamic block glitch

Can someone take a look at this block. I am using an array, stretch, and visibility states in a lookup table. It works fine if you change from any of the states listed incrementally. But if you change a state higher than 6 and then back to 2 or 4, the array starts going in the opposite direction. Any ideas?

Brad

AMPTEST2.dwg

I just noticed a few more odd things:

There is a "custom" selection in the lookup table that I cant get rid of

No matter which selection I choose when using the block, "custom" always stays checked

You may also notice that the array value in the lookup table increases after state 6 from what the offset is set to. This is because for some reason it was not appearing for these records unless it was greater than the offset.

hmmm...

Remove the linear paramter for the array from the selection set for the stretch action, your lookup table is specifying an array length and a stretch length, but the stretch is modifying the array as well. This results in an array that does not match the lookup table, generating a "Custom" flag in the lookup and causing the array to glitch.

I know this is wayy off topic, but did you intend your email address to be your username?

only it leaves your email wide open to all kinds of harvesting programs

I know this is wayy off topic, but did you intend your email address to be your username?

 

only it leaves your email wide open to all kinds of harvesting programs

at least he has one less user name to remember, i have 8 alone that r just work related at the moment.