cburk Posted February 19, 2009 Posted February 19, 2009 I am trying to figure out if there is a way to feather line out in AutoCad2007. I am trying to feather the lines out of of a hardwood floor around text, please note attached... Any suggestions? Quote
uddfl Posted February 19, 2009 Posted February 19, 2009 What does feather out mean? Trim? Mask? Quote
wannabe Posted February 19, 2009 Posted February 19, 2009 Well a mask would cover the portions of line that aren't obscured by the text...I think. So, what other options...TRIM or maybe you could redo the lines as a hatch with island detection. Quote
cburk Posted February 19, 2009 Author Posted February 19, 2009 If I were hand drafting this, I would taper the line off so it gradually got narrower and then disappear... Quote
wannabe Posted February 20, 2009 Posted February 20, 2009 Then my next suggestion is that you make the lines polylines using the PEDIT command and then in the properties you can change the starting and end widths of the line; this may need a bit of experimentation but in theory will make the line decrease in width as it progresses. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.