ziemerd Posted February 20, 2009 Posted February 20, 2009 I have a drawing that I need to copy part of and paste it into a new drawing but not everything pastes. All the layers are turned on and none are frozen. Any ideas? Thanks. Dawn Quote
lpseifert Posted February 20, 2009 Posted February 20, 2009 Are any of the layers in the source dwg locked? Quote
ziemerd Posted February 20, 2009 Author Posted February 20, 2009 None of the layers are locked. Quote
uddfl Posted February 20, 2009 Posted February 20, 2009 How are you selecting the objects? Window? I've had instances in which blocks have had insertion points very far away from them (very annoying) so they will not be selected by the window... Check the number of objects found when you select them when copying and after pasting too. Also, this could be a case of proxy objects not being shown. Quote
chauncy274 Posted February 23, 2009 Posted February 23, 2009 I have a drawing that I need to copy part of and paste it into a new drawing but not everything pastes. All the layers are turned on and none are frozen. Any ideas? Thanks. Dawn Unusual... try typing 'select' then 'all' and copying and pasting everything into the new drawing and delete what you don't need. It's most likely an odd insertion point like what was previously said. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.