Make Number Leaders Vanish

[Jadeous]

Ok, so I have numbered the parts in my drawing and pulled the little number bubble away and streached the leader out. My problem is that the Bossman doesn"t want leaders! So now I am stuck with Leaders! I heard of a command that solves this problem, but it has slipped my memory. Please help. Thank you.

[lpseifert]

If you're talking of Multileaders with a Detail Callout Block, in Properties you can set the Leader type to none.

[Jadeous]

I am using the CADDuct item numbers in ADT. When I move the number out it has a pink triangle attached to it. If I pull the triangle out it creates a leader.

[Strix]

let's put your question in the ADT forum then, where it should be spotted by somebody familiar with that function :thumbsup: