xbolt.lsp

[simon]

Have xbolt.lsp from a few years back when I was using Acad2000, now have 2005, which I am unable to get working correctly.
Should this work with 2005 version?
I have tried to load the lsp, and it says that it has been successful, but acnnot find out how to use it, it previously loaded a menu, or topic on menu.
Plz help or advise of a newer bolt/nut add-on drawing tool, thanks.

[gmolloy]

Hi. Sorry if this seems obvious but when you appload the lisp are you then doing performing the menuload command? Not familiar with this lisp but it would seem that if it is loading OK then it should work. Also open the lisp file to see if there are any notes or commands that you may be missing.... Hope this helps you somehow! :)

[simon]

thanks 4 reply

I have tried the menuload, but am not doing this successfully, as i keep deleting current menus and toolbars! In my opinion the Help does not explain how to do this very well!

[gmolloy]

If the xbolt lisp used to load a menu then you need to open the .lsp file using Notepad or Textpad and see which directory it is putting the .mnu file. Once you have found that you can do the appload command and browse to the location where the .mnu file is and load it.