Image paths

[fireball_xl5]

Hallo! Ive got a title block with an image inserted into it with the path saved. Once the blocks inserted into a drawing the image doesnt load and the path is still correct but just needs re-adding and saving again for it to appear....

any ideas before i go play stampsies with my laptop?

cheers!

[Big Mike]

I'm just thinking out loud here but...it may be that when you created the title block, the image was not selected because 'Imageframe' was set to 'Off'. The file would still be attached to the drawing and so the path would be saved for reloading...but the image itself would not be part of the block.

Try opening the title block file and check that the image is selectable...and that it's selected...and wblock the file. Then insert it into another drawing.

I might be way off...but hopefully this will help.