Editing Block Ref

I was wondering how do I enable the block editing.

I've tried set blockeditor 1 but it didn't work.

You can use the commands REFEDIT or BEDIT

You can also double click the block to get into Refedit mode

You can also select the block, right click and select either "Block Editor" or "Edit Block in Place"

Sodium, I have already replied to your question. If you need further assistance, please respond in this thread.

I have deleted the other two threads you started, where you were asking this same question. Please don't start another thread about block editing.

I'm sorry I must've double posted by mistake

I want to delete block reference I've created how do I do that? ( ones I've deleted the reference to)

You mean you've deleted the block and now you want to remove the reference from your drawing?

Use the PURGE command.

And I've deleted yet another duplicate thread. I'm hoping we won't see any more?

Thanks, and no sir

You're welcome. Let us know if you run into any more problems.

Cad64

I have a similar problem.

If I select refedit from the tool bar or type it states unknown command.

If I double click the block it states unknown command (bedit).

If I select the block then right click then select block editor or edit block in place it states unknown command.