Maxelkat Posted April 22, 2009 Share Posted April 22, 2009 I'm working on a drawing with parametric blocks in, but nearly every time I try to edit a block in the Block Editor I get the following message: INTERNAL ERROR: !dbutil.cpp@698: eWasOpenForWrite It then offers me the chance to save changes, however, when I tried to open the 'recover' file, I was told the drawing was not valid. Any ideas folks, as I'm pulling my hair out, (and I don't have very much to pull out). Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 22, 2009 Share Posted April 22, 2009 First, take a look at this post to the AutoDesk Discussion Groups similar to yours. http://discussion.autodesk.com/forums/thread.jspa?messageID=4874266 Let us know if the "fix" works for you or not. Quote Link to comment Share on other sites More sharing options...
Maxelkat Posted April 22, 2009 Author Share Posted April 22, 2009 I never would of guessed it was a linetype problem!! Thank you remark, that's fixed it. Quote Link to comment Share on other sites More sharing options...
ReMark Posted April 22, 2009 Share Posted April 22, 2009 Well until you asked the question I never would have thought of it either. You are entirely welcomed Maxelkat. Thanks for getting back to us too with an update. Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.