Electroman7979
8th May 2009, 11:23 pm
I am trying to set up all my layers so I can keep all my 24VDC and 120VAC power separate. So when I click on the automatic wire numbers I can re-number all my wires at once.
However, this works fine when I click on "active drawing". But when I try to do multiple drawings or the whole project, it does the first page and then gives me this error:
" Wire numbers: 6 New, 0 Updated, 0 Fixed
Error: bad argument type: stringp nil"
Has anyone ran into similar issues? or do I have a something goofy going on?
Any help would be appreciated!
Thanks,
James
However, this works fine when I click on "active drawing". But when I try to do multiple drawings or the whole project, it does the first page and then gives me this error:
" Wire numbers: 6 New, 0 Updated, 0 Fixed
Error: bad argument type: stringp nil"
Has anyone ran into similar issues? or do I have a something goofy going on?
Any help would be appreciated!
Thanks,
James