center drawings within seperate boxes?

I'm just curious, I need to make 4 drawings on the same page in 4 separate squares, but they need to be centered. Is there a snap setting that would enable this or is it just trial and error?

Use the mid-between-two-points (m2p) or shift+left mouse button while in a command.

Or Otrack with Osnap, acquire midpoints, etc. See help file.

You can also use .x and .y filters, or simply draw construction lines from corner to corner and the intersection is the middle, erase the lines.

Draw a 2point circle from a mid point or corner to opposite mid point or corner, use center of circle, erase.

Any of those, but don't use trial and error.

Ahh, thank you that should do the trick!