View Full Version : Hole Feature
8th Sep 2005, 08:48 pm
When I want to use the hole feature to produce a pipe thread, my options are for metric ISO Pipe threads. How do I get the inch option?
8th Sep 2005, 10:39 pm
What version ? :?
That's not in vanilla acad, unless it's a LISP or other such add-on.
8th Sep 2005, 11:16 pm
I am using Inventor 8. The "hole feature" that's a part of extrude.
9th Sep 2005, 05:17 pm
Oops thought this was the acad forum. :oops:
In IV7 go to the standards men and check in there.
Or Document settings and the units there. I don't have
excel on my home machine to check.
9th Sep 2005, 06:57 pm
Sorry about being on the wrong forum. I will make a new post on the Design Forum.
9th Sep 2005, 07:12 pm
:( Opps, You moved it.
I looked at Document Settings and the Units, the current settings are for inches.
9th Sep 2005, 07:42 pm
So that cured it ?
I thought I read this post the other day and it was NOT
in the IV forum so post my first reply above. :oops:
Although I can move topics, as a moderator, I did not move this one.
Post up any other questions 8)
9th Sep 2005, 07:50 pm
No. That didn't cure it.
9th Sep 2005, 09:26 pm
I moved the topic to the Inventor forum - sorry for the confusion guys. :geek:
10th Sep 2005, 11:20 am
Aha ! I thought that was the night I had a few carlsbergs.
I thought it may say moved at the top.
If I move topics I'm gonna edit the post and say moved !
PS quiet here this morning, I'm of climbing inside out of the rain
at www.adventurescotland.com 8) :D :shock:
Powered by vBulletin™ Version 4.1.2 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.