Command Line Variable Options?

Hi all,

I've been searching through the forums, I know i've seen the answer before but i can't find it, so here goes:

I've just recently had my computer updated to a newer model so

before that happened I backed up my workspaces/profile/cui etc,

everything else haworks like it did before, apart from 1 small problem,

every time i enterd something in the command line before, whenever i

pressed the up arrow it would repeat what i put, now however it's

always coming up with the last absolute co-ordinates I was at, which

is a little frustrating.

Example:, I've used the DIV command on a line and now have a set of

nodes I can snap to - i select XLINE and type in NOD, click on the

first node, and then out of habit i press UP > ENTER, but this is now

putting my next line ontop of my first one, not saying NOD at

command line anymore, just a set of co-ordinates.

If anyone knows which variable it is that i need to change, please let

me know, as I rely on being able to quick-repeat commands that way,

where as now i've had to open every toolbar out or every time i want

to re-use a command I have to re-type it.

Thanks

This is updated each year :wink:

Edit... didn't really read the full post clearly...

Edit of edit... are you still in the command?

nope, i've read the list VERY usefull if you already know part of command name, but i've forgotten the whole thing.

Are you still in an active command?

nope, i've done the nodes but it even happens when no command active, say i want to use LINE again, i press up with no active command going on and its still coming up with last used co-ordinates

Inputhistorymode

Alanjt THANKYOU!!!!!!

That's been driving me bannana's, i got to remember that command

*runs off to write it down*

Alanjt THANKYOU!!!!!!

 

That's been driving me bannana's, i got to remember that command

*runs off to write it down*

No problem, had the same problem when we switched to 06 (I think that was the version).

I just keep a list of setvars in my startup file that issue each time.

(AT:Setvar "inputhistorymode" 0)