GOS
12th Oct 2009, 07:52 am
Hi All,
After trying all the conversions I found that the best way to convert these files are by exporting them to ACIS SAT or STEP AP214. But make sure the assemly are all individual parts and not grouped.
From there I open them in Inventor2010. But now when I open these exported files the endges seem to be all jagged in appearance.
Please see attached .dgn(original), .sat(Exported SAT) and .ipt
Does any one know if there is any other better way of importing these files.
Thanks,
GOS
After trying all the conversions I found that the best way to convert these files are by exporting them to ACIS SAT or STEP AP214. But make sure the assemly are all individual parts and not grouped.
From there I open them in Inventor2010. But now when I open these exported files the endges seem to be all jagged in appearance.
Please see attached .dgn(original), .sat(Exported SAT) and .ipt
Does any one know if there is any other better way of importing these files.
Thanks,
GOS