Nick-H- Posted October 15, 2009 Posted October 15, 2009 This site has been so helpful, i just keep thinking of things I know this is possible in MEP, but i want to make it in ACAD is there anyway of making a block, automaically trim or not show the line its placed on, because i have to place IV valves on lines, everytime i do it i have to trim the line underneath, in MEP it does this automatically Nick Quote
Nick-H- Posted October 15, 2009 Author Posted October 15, 2009 Cheers, I cant belive ive never used that command before Quote
ReMark Posted October 15, 2009 Posted October 15, 2009 You can design your blocks to be "auto-breaking". Read this: http://www.afralisp.net/lispa/lisp52.htm Quote
Nick-H- Posted October 15, 2009 Author Posted October 15, 2009 Christ ill be getting a payrise by end of week at this rate, i solved well you lot have solved and speeded up quite a few things Quote
ReMark Posted October 15, 2009 Posted October 15, 2009 "Christ ill be getting a payrise by end of week at this rate..." You'll also be buying the first round or two down at the pub. Quote
Nick-H- Posted October 15, 2009 Author Posted October 15, 2009 Im sure it will of been spilt by the time it reaches you, i could tell my freind in minesota to drop you one off, but she would probably drink it first haha Quote
Tankman Posted October 17, 2009 Posted October 17, 2009 I'm sure it will of been split by the time it reaches you. I could tell my Friend in Minnesota to drop you one off, but she would probably drink it first ha ha! The story of my life! Another dead soldier! Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.