ADT 3.3 menus got hosed

[Galingula]

Some where along the lines in the last few days I have lost the ability to have a menu with both AutoCAD and ADT stuff available.

I can load AECarcX and Acad menus, but the AECarcX has ONLY ADT commands and bars, and Acad has ONLY AutoCAD things available.

Currently I'm switching between the two, but this is undesirable.

Any help would be appreciated, thank you.

[f700es]

Some where along the lines in the last few days I have lost the ability to have a menu with both AutoCAD and ADT stuff available.

I can load AECarcX and Acad menus, but the AECarcX has ONLY ADT commands and bars, and Acad has ONLY AutoCAD things available.

Currently I'm switching between the two, but this is undesirable.

Any help would be appreciated, thank you.

I got this a few years ago and I don't think I ever found a solution. I had to reinstall :x ADT. I would search the AutoDesk ADT 3.3 forums to see if a solution ever came about.

[Galingula]

After poking the interface with a stick a few times:

use the MENULOAD rather than MENU to add more menu files into the one you're using.

You can LOAD the acad menu than MENULOAD and add the aec menu to the pot as well. Then you may pick commands and menus from either

[f700es]

After poking the interface with a stick a few times:

use the MENULOAD rather than MENU to add more menu files into the one you're using.

You can LOAD the acad menu than MENULOAD and add the aec menu to the pot as well. Then you may pick commands and menus from either
Ah...that's good to hear. Like I said this was about 2 years ago that I got that. Might not even be the same problem but I do remember losing all of my AEc menus. Glad you got it figured out.