BillB Posted February 15, 2010 Posted February 15, 2010 Hello again, Was doing the usual Ballooning and BOM Parts List for an Exploded view of an assembly that I created, turned out well and everything was good. Went to open it up again this morning and now all my Balloons and the list of part are gone, the Parts List header is there and the exploded view is still there. Any ideas or suggestions on what I may have "clicked" or done to have this happen? Sure hope I don't have to go back through and re-balloon and redo the parts list again. Suggestions, comments, remarks are very welcome. Thanks in advance. BillB Quote
Safwah Posted February 24, 2010 Posted February 24, 2010 Try double clicking on the parts list to open it, should give you a message about updating it or something so say yes, once the parts list opens just hit ok and the balloons should show again. Quote
BillB Posted March 5, 2010 Author Posted March 5, 2010 Hey Safwah, Sorry for the slow reply, thank you for the info, I'll give it a try and see how that works. Hope to be able to help you out one day, take care and thanks again. BillB Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.