Kremer Posted February 24, 2010 Share Posted February 24, 2010 For some reason every dimension I'm placing in paper-space is reading it's length in paperspace as opposed to modelspace, i.e. 1:1 instead of 1/4"=1' (So 1' in model is showing up as 1/4" paper, where as normally it would display 1'). I've had this problem occur before but I was always able to delete it and the next dimension would usually work. In this case I've restarted ACAD and it's still doing it. Thanks in advance to anyone who's cured this ailment before. Quote Link to comment Share on other sites More sharing options...
ReMark Posted February 24, 2010 Share Posted February 24, 2010 When you make your picks in paper space use Osnaps. Quote Link to comment Share on other sites More sharing options...
Kremer Posted February 24, 2010 Author Share Posted February 24, 2010 I always do, I'm doing everything like normal on a system I use daily. It's alittle frustrating but I've just had to switch back and forth between model/paper double checking lengths. Quote Link to comment Share on other sites More sharing options...
Hoozin Posted February 24, 2010 Share Posted February 24, 2010 Check DIMASSOC, I think you want it at 2, but check the helpfile too. Quote Link to comment Share on other sites More sharing options...
lpseifert Posted February 24, 2010 Share Posted February 24, 2010 Try setting Dimscale=0 Quote Link to comment Share on other sites More sharing options...
SuperCAD Posted February 25, 2010 Share Posted February 25, 2010 Try dimensioning in modelspace and use annotative scaling. Quote Link to comment Share on other sites More sharing options...
Kremer Posted February 25, 2010 Author Share Posted February 25, 2010 Check DIMASSOC, I think you want it at 2, but check the helpfile too. Bingo! Thank you all so much Quote Link to comment Share on other sites More sharing options...
Hoozin Posted February 25, 2010 Share Posted February 25, 2010 Good to hear Quote Link to comment Share on other sites More sharing options...
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.