whel_13
14th May 2003, 10:59 am
Hi guys! It’s me again J. In Autocad LT 2002
Here’s the set up.
New drawing.
On the command line type
DDVPOINT
<select from X axis 315, XY plane 30> <you should be on "Absolute to WCS>
then click OK
from drop down. select tools
then drafting settings
then on the Snap and Grid click on ISometric snap
I want to draw a circle in the isometric projection with axis on the Y and Z axis.
In this set-up, could you check the following command and orientation if its right
Ellipse <press enter>
<select Isocircle>
<press F5 and select isoplane left>
<type any radius>
<press enter>
Here’s the set up.
New drawing.
On the command line type
DDVPOINT
<select from X axis 315, XY plane 30> <you should be on "Absolute to WCS>
then click OK
from drop down. select tools
then drafting settings
then on the Snap and Grid click on ISometric snap
I want to draw a circle in the isometric projection with axis on the Y and Z axis.
In this set-up, could you check the following command and orientation if its right
Ellipse <press enter>
<select Isocircle>
<press F5 and select isoplane left>
<type any radius>
<press enter>