mahmoud abdallah Posted April 8, 2010 Posted April 8, 2010 how could i make a set of gears as intigral parts with a shaft in the same time i need to make the gears with the design acclerator to enable calculations thank you for help Quote
shift1313 Posted April 8, 2010 Posted April 8, 2010 you can make the gears with design accelerator and then edit them to cut a key way or spline. Just be aware of the constraints that are placed on these design accelerator parts when created. Quote
mahmoud abdallah Posted April 8, 2010 Author Posted April 8, 2010 ok it is easy to produced but one gear of the gear train is mounted on shaft to bee free to rotate by using roller bearing the other gear is single part with its shaft so this the case i fall on do you have a solution? Quote
shift1313 Posted April 8, 2010 Posted April 8, 2010 you can edit each gear individually. You should be able to key one gear to the shaft while the other is free to rotate. Quote
mahmoud abdallah Posted April 8, 2010 Author Posted April 8, 2010 no no the case is one gear is single part with a shaft and the other is temprary engaged with its shaft engaged and disengaged Quote
shift1313 Posted April 8, 2010 Posted April 8, 2010 im having trouble visualizing your part. can you put up a screen shot or sketch to help me see it? Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.