Inventor 2010:changing tolerance possible?

Hi all,

Is it possible to change modelling tolerance in Inventor? With this I mean: For example I need to find intersection points of two lines but I can't cause these lines are 0.005 mm from eachother. I was wondering if I could find these intersection points anyway if I could increase the tolerance to for example 1mm?

Thank you in advance!

I don't understand the question - attach your file here.

If I understand the problem at all - create a sketch point.

Add a coincident constraint between the point and the first line.

Add a coincident constraint between the point and the second line.

This will give you the apparent intersection.

The more I try to figure out what the problem is the more it doesn't make sense.

Attach the file here.