Jump to content

Titles instead of number values in dynamic blocks


tonyd1000

Recommended Posts

i have a window (on plan) dynamic block which has various actions, and attributes attached to it to extract information from to form schedules, question i'm asking is this; when i extend the cill to a pre-set depth, instead of a numeric value i.e 50mm (2"0), 100mm (4") etc showing up in the extracted data table, i want the extracted data to say stub, standard or extended, just wondered if this was possible and if so how?

 

i hope the is above is clear, many thanks in advance :)

Link to comment
Share on other sites

When you get 2010 you will be able to make use of the new 'Block Table' parameter, which allows you to add your own column of information to a look up table.

 

Come to think of it, can you do that with a standard look up table?

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...