juskojj Posted April 16, 2010 Posted April 16, 2010 when i save a 2000 version dxf to a R14 version dxf i loose constraints and have open ends any ideas why this happens or how to fix it? Quote
nukecad Posted April 16, 2010 Posted April 16, 2010 Its probably because R14 is from 1997 i.e. 13 years old and does not support features like dynamic constraints that were introduced with later versions. Only suggestion is save to a later version not R14. Quote
Coosbaylumber Posted April 19, 2010 Posted April 19, 2010 I know that if there were any Polylines, or used to be polylines that got trimmed, then R-14 will not show them properly. or least not as envisioned. Do not go one step further after the DXF-OUT, but getout of the process and close the file immediately, and then reopen it up. For the save-as processs will then again begin on altering your drawing to latest format, and one in which R-14 may not recognise properly. Just take a quicky look at the new filee in M-S Notepad or something for a change in character. Wm. Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.