darylt Posted April 25, 2010 Posted April 25, 2010 Hello All - Newbie to this forum. I have an irratating problem of which I would be greatful for some advice. I have autocad LT 2010 loaded onto Windows 7 64bit. Whilst using autocad lt it seems that I have a 'gap' in drawn lines of which dissapears when I zoom into the area. Grid/snap are not turned on. Is this a software, graphics card or monitor issue? Any advice will be much appreciated. Thnak you all, Daryl Quote
alanjt Posted April 25, 2010 Posted April 25, 2010 Sounds like a linetype. When you zoom in, what happens if you Regen? Quote
darylt Posted April 25, 2010 Author Posted April 25, 2010 Thank you for the reply - If I zoom in on the line or regen the line becomes solid again. linetype is continuous. Thanks, Daryl Quote
Tankman Posted April 25, 2010 Posted April 25, 2010 Purge, audit, regenall, save. THE four commands for every drawing! Welcome to the forums! Where are you posting from? Quote
darylt Posted April 25, 2010 Author Posted April 25, 2010 Thank you Tankman for your response - This is happening in every drawing and has only been doing so since use on Windows 7 64bit. Will your reccomendation cure this problem? Daryl Posting from Wales, United Kingdom Quote
darylt Posted April 25, 2010 Author Posted April 25, 2010 Have tried the above suggestions but i still have the same problem - Must be a monitor, graphics card or operating system issue? Daryl Quote
Recommended Posts
Join the conversation
You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.