Jump to content

line to poly


Recommended Posts

Welcombe to the forum Mart.

 

The answer is yes you can.

Start the command EDIT POLYLINE then type M to choose multiple. It then prompts you to choose the lines arcs etc you want to join together. It then asks if you want to turn them into polylines!! Enter Y. Then choose JOIN. Then enter a FUZZ distance This is because your lines may not actualy touch at the ends. Enter a figure you think is bigger than any gaps you may have, then press return. You should have a contiguous POLYLINE.

 

Hope thats all understandable:)

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...