filleting the corner of a wedge

[jcad]

Hi I am using AC2005 and I need to fillet one corner of a wedge. What would be the process for this. Everytime I pick the three edges which extend from the corner I end up filleting those edges also, but only need the corner. Thanks for any help!

[scj]

As I know filleting is working on edges - not for corners.
But you can slice the corner by defining 3 points on the egdes.
Regards
Jochen

[aledtaylor]

If the wedge is a solid, you could create a block, position it across the corner and 'subtract' it from the wedge.