Jump to content

Nesting Check


Pete_IC

Recommended Posts

Dont know if a lips is what I'm looking for, but if it can be done someone on here will know how.

 

Where I work we do a large amount of nesting and what I'm looking for is a way of checking that everything is nested.

 

I figured if I take the nested drawing and parts drawing and put them into one file (as per attachment)

and then have a lisp that check that there were doubles of everything, I dont know if its better to go off part names or polyline shapes but would be useful if it some how listed or changed the layer what parts were not doubled up.

 

If anyone has any ideas on how to do this or has a lisp that does this that would be awesome.

 

Thanks

Pete

Nest Check.dwg

Link to comment
Share on other sites

Join the conversation

You can post now and register later. If you have an account, sign in now to post with your account.
Note: Your post will require moderator approval before it will be visible.

Guest
Unfortunately, your content contains terms that we do not allow. Please edit your content to remove the highlighted words below.
Reply to this topic...

×   Pasted as rich text.   Restore formatting

  Only 75 emoji are allowed.

×   Your link has been automatically embedded.   Display as a link instead

×   Your previous content has been restored.   Clear editor

×   You cannot paste images directly. Upload or insert images from URL.

×
×
  • Create New...